![]() |
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Why would you invert the polarity of the mid range? posted by The Real Dick Hertz on August 21, 2007 at 20:36:26:
The driver is inverted in relation to the other drivers. Actually, instead of a dip, you'll get a reinforcement at the crossover points. Like many three way designs (the Hales had similar issues), the inverted midrange gives a much steeper crossover slope because of the cancellation to the adjacent drivers. However, I find that getting the timing correct is more important than the slight anomalies in the FR, as you don't always have music playing in the reinforcement band width, which is actually smaller than you may suspect.
IIRC correctly, crossover on the woofer is quite high about 400-500HZ since the midrange has no cabinet to lower the response of the driver. At any rate, it is a simply thing to try, merely a wire swap and easily reversed should the user not like it. On the upper models from Alon, the speakers are tri-wired and so inverting polarity is even easier.
I have sold all the Alon models from the 1's through the 5's, and all exhibit mismatched polarities of the drivers, specifically the midrange. I used to demo them and sell them with the mids reversed. Sold quite a few that way, too.
Stu
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Why would you invert the polarity of the mid range? - unclestu52 20:50:16 08/21/07 (7)
- RE: Why would you invert the polarity of the mid range? - kenster 21:20:41 08/21/07 (5)
- In my experience - unclestu52 00:22:41 08/22/07 (4)
- RE: In my experience - mingles 02:14:25 08/22/07 (3)
- For me - unclestu52 19:58:30 08/22/07 (2)
- RE: For me - mingles 12:57:57 08/23/07 (1)
- RE: For me - unclestu52 18:53:20 08/23/07 (0)
- Forgot to add - unclestu52 21:03:33 08/21/07 (0)