Home Speaker Asylum

General speaker questions for audio and home theater.

Full range drivers do not exist-

But really wide range midrange drivers do and are called 'full range'.

To your question, the driver likely has response above the cutoff you have planned for the tweeter. If it does then there will be comb filtering effects between the drivers which contributes to harshness. So its a good idea to filter out the highs with a crossover for the 'full range' driver.

On the bottom end, you have a different problem. Frequencies lower than the horn supports exist. The driver is not loaded below the horn's cutoff frequency so it will flop around with the lower frequency bass notes. This causes Doppler Effect distortion which contributes to congestion (so at low volumes the speaker might be very convincing but crank up the volume and it falls apart).

For this reason a high pass filter should be used with the driver, preventing bass notes from messing with it. This is why in the old days you saw high efficiency loudspeakers with 15" woofers, which had no problem getting up to 500Hz, which is a good place to cross over to the main driver since the capacitors needed to do that won't be ridiculously large.

You can supplement the bass with subs of course but if you don't knock the bass out of the 'full range' driver you'll have limited dynamic range before the speaker seems to fall apart.



Edits: 07/23/24

This post is made possible by the generous support of people like you and our sponsors:
  McShane Design  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.