|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
174.93.153.38
In Reply to: RE: Need help in replacing receiver dial bulb with correct one posted by Ron Oehlert on May 20, 2010 at 00:24:28
Thanks so much Ron for this! I was thrown off by that "code" because I thought I had read here that some of these bulbs were rated in milliamperes instead. And "VO" for volts is strange too for the newbie "futzer" I still am!...
Now off to Maddison Electronics and back home to fix that pup... That SX-535, now generally cleaned up, sure sounds sweet to me BTW! I like how it "develops" at low volume - I play mainly with headphones - and it has sonic qualities that seem lacking with my regular Pioneer SA-7500-II.
Follow Ups:
Parts Express has 8V 0.25A bulbs - close enough to 0.3A (300 mA)
OK, I get that "O" now, and thanks a lot for that link!
Would you say that a, say, 12 V bulb be perhaps too bright, thus "unbalancing the illumination" of the dial?
A 12V bulb will be dimmer, not brighter since it's only operating at 8V.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: