In Reply to: No, you read me correctly the first time. posted by Al Sekela on June 1, 2008 at 21:35:33:
Let's see: damping involves the introduction of lossiness. In a mechanical system, that would call for a shock absorber. In an electrical system, resistance would be needed. But how to introduce resistance into a shield? Interrupt the shield every few inches and solder a resistor from one section to the next?
Hmm, maybe not. How about a resistor between shield and center conductor every few inches. It would load down the source, though. Okay, resistors between shield ground and chassis ground? With a third wire to carry the chassis ground?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- OK, so how do you damp a shield? - robfoto@sbcglobal.net 21:46:38 06/05/08 (4)
- You extract energy from the electric or magnetic fields. - Al Sekela 08:38:51 06/06/08 (3)
- Carbon? - robfoto@sbcglobal.net 18:05:26 06/11/08 (1)
- RE: Carbon? - Ted Smith 18:46:38 06/11/08 (0)
- Tease! :-)) nt - andyr 03:04:12 06/07/08 (0)