|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
|
|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
In Reply to: fisher 400 troubleshooting/repair posted by mattk on December 21, 2004 at 07:01:34:
Hi,This is a common error in restoring these receivers. The 7868 outputs cathode v14 or v15 left channel use the cathode pin for grounding another component. If cathode resistors have been installed on all cathodes and the other component is still connected to the cathode pin then this WILL cause this problem.
Each cathode through a 10ohm resistor to ground only no other components connected to the cathodes of the outputs. If they are they must be separately connected to ground on their own. A schematic will make this obvious.
I doubt that this unit was working without distortion after the fisher mods...This is easy to do if you are not experienced in adding the cathode resistors in this unit...
Good Luck , AJ
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: fisher 400 troubleshooting/repair - AJ 18:07:39 12/21/04 (1)
- Re: just to make sure - - mattk 07:27:23 12/22/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
