|
Radio Road Which tuner to get and getting the most from it. Thank God, for the radio! |
|
|
|
Radio Road Which tuner to get and getting the most from it. Thank God, for the radio! |
|
In Reply to: Panasonic Table Radio Problem posted by Andy Traxel on August 13, 2006 at 16:31:08:
You need an alignment on your AM dial part.If you want factory spec, you need to get a factory service manual to service your AM IF cans and/or your VC top screws.
You may try by trial-n-error by first getting a permanent marker pen and mark all the corresponding screw slot positions on your VC, and then while you have your selector set to AM, carefully adjust your screws until it "dials" in to proper frequency.
Anything goes wrong, you can always reverse-engineer your screw settings based on the permanent marker markings.
Q.
p.s. don't forget to check all other components for runaway or out of specs.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Panasonic Table Radio Problem - Quest 18:22:32 08/13/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
