Tube DIY Asylum

RE: Increase L in pi network

101.183.96.246

This Post Has Been Edited by the Author

In Reply to: RE: Increase L in pi network posted by Sidewinder on September 22, 2017 at 00:15:20

If you are looking for more speed: "tighter" dynamics, a sense that complex music does not turn to mush, and a more delicate sense of touch, I don't think that in your case increasing the inductance and DCR will deliver. Actually, it will probably slow PS recovery - exactly what you don't want - and your B+ would drop a little. You are running a small final capacitor so I think recovery will be very important.
When I was designing the PSU for my current SET amp build - a few years ago now - I digested a lot of info from here, elsewhere and various articles, deciding that a Pi filter would be the way to go for a SET amp (putting aside flywheel, LSES etc. for now). The PS would have low impedance down to frequencies of interest, fast but critical-ish damped recovery, and sufficiently low ripple (which is not as low as most provide); these objectives affect one another. From memory, I calculated the final capacitor size to give me low enough impedance to my output tube, then calculated roughly the resistances I'd need for sufficient recovery times (40mS or so). Once I had some ballpark targets and values I could keep constant (PS TX resistances, rectifier types, choke L and DCR etc.) I simulated and refined in PSUD... a lot. I was able to meet my criteria, but could not do it with off-the-shelf parts... the choke being perhaps the most important component. I ended up with 5U4G - 10uF (metalised film) - 7Hy (<10 Ohm DCR) - 120uF (metalised film) per channel.
When selecting a choke for use in a Pi filter, use sufficient Hy to keep your ripple under control (in combination with cap sizes etc.) and go for the lowest DCR you can, while still being satisfactory in other parameters. Problem is, such a choke with low (enough) DCR can be expensive.
As an aside, I ran PS calculations and simulations for a range of commercial and DIY SET pre and power amplifier designs... most were pretty horrible having weird resonances, (what would be) audible ripple, ringing, glacial recovery... Interestingly, (c)LCLC PS being some of the worst.
Apologies if some of the info is vague - it was over a year ago and I've forgotten much!
Cheers,
91.

"Confusion of goals and perfection of means seems to characterise our age." Albert Einstein

Edits: 09/23/17 09/23/17

Follow Ups: