In Reply to: RE: I agree making some vents might solve your problem. posted by vinnie2 on June 2, 2017 at 18:08:20:
When I build amps these days I raise the top plate off the side panels with a washer at each screw, enough for air to escape. It's a bit hard to tell from your photo, but you might be able to raise your top plate a tiny little bit, either with washers on the screws or some other mechanism. If you can get some air moving through the small gap then the total for all four sides would be considerable and it will be virtually invisible.
ray
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I agree making some vents might solve your problem. - RayP 00:28:46 06/03/17 (1)
- RE: I agree making some vents might solve your problem. - vinnie2 04:24:41 06/03/17 (0)