|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Replacing 9-pin sockets posted by FenderLover on May 29, 2017 at 07:57:27:
I tightened up the tube socket pins this morning with wooden tooth pics.
They are now much tighter than they were previously.
So far....no pops, clicks, or other noise.
We will see if that lasts or not?
If they do get noisy again, then out they go!
Steve
This post is made possible by the generous support of people like you and our sponsors:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
