|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: question for Eli... posted by Dave Cigna on April 30, 2007 at 15:47:25:
Yes to both. This is the amp that was running good before and it had about 750 vdc for B+ then, not sure about the about the idle current, but the bias was set at about -115vdc. And yes, this is the 1450 volt tranny.
I think it's more likely to be the 6au4's as they were not on the old amp and if I am reading the tube manual correctly they draw a lot of juice. I hope your guess about them conducting all at once is not the problem, because I am using them to eliminate power spikes with their slow warm up.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: question for Eli... - Vinnie 17:58:12 04/30/07 (2)
- Re: question for Eli... - Eli Duttman 20:11:35 04/30/07 (1)
- Re: question for Eli... - Vinnie 03:36:22 05/01/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
