I would appreciate input on choosing a great DIY phono stage to use with the following. Music is mostly Jazz & Blues. Up to $2,500 in component parts is OK.My preamp is a Berman 76 from Sound Practice issue 13. Currently I am using a battery biased 6LS7 RCA phono stage with Lundahl LL9206 step up trannies for the Denon 103. I would like to upgrade the phono stage if possible. DIY only.
Other equipment is Angela 91 300B mono blocks with beefed up power supply (additional 100uf + 10 hy choke). Speakers are Klipsch Jubilee clones. TT is VPI Aries II.
What about Allen Wrights FVP5? Other suggestions?
Additional equipment specs: The following is based on my limited knowledge and may not be accurate.
Input impedance of Berman 76 ~270K
Output impedance of Berman 76 ~320 ohms
Input impedance of the current phono stage ~47K
Input impedance of Angela 91 ~221K
Some measurements I took they may be helpful:
Voltage measurements were all with HP Digital Multimeter. These test were done with an Alps 250K volume control in the 76 which has been replaced with a 100K Daven stepped attenuator, 19 step 2db/step with a series 150K resistor for phono to maintain the 220K min. required by the RCA phone stage.
1Khz test tone @ .421 vac into 76 Pre amp from a test pink noise CD WE-91 starts to clip @ 7.75 vac at it's output into an 8 ohm resistor, per my scope, with an output from the 76 @ .603 vac into the input of the WE-91, which is right at 50% on the 76 volume control.At 75% on the volume of the 76 it is putting out 2.22 vac and at 100% on the 76 volume it puts out 2.79 vac. No clipping was observed on the 76 output at full volume.
This post is made possible by the generous support of people like you and our sponsors:
Topic - DIY phone stage recommendation for.. - rigma 14:24:07 04/24/07 (14)
- Re: DIY phone stage recommendation for.. - JimL 18:43:06 04/25/07 (0)
- LCR EQed phonostage! - Thomas Mayer 00:58:26 04/25/07 (0)
- What about Allen Wrights FVP5? - Allen Wright 22:40:32 04/24/07 (0)
- Re: DIY phone stage recommendation for.. - John Swenson 18:37:38 04/24/07 (8)
- Re: LCR Design - danlaudionut 11:46:28 04/25/07 (2)
- Re: LCR Design - rigma 13:21:27 04/25/07 (1)
- Re: LCR Design - danlaudionut 13:27:33 04/25/07 (0)
- Re: DIY phone stage recommendation for.. - IRON-LEIF 08:16:14 04/25/07 (1)
- at a tiny fraction of the price! - BlackPlasticSound 14:04:59 04/25/07 (0)
- Re: DIY phone stage recommendation for.. - Stephen R 04:28:23 04/25/07 (2)
- What is the gain when you switched the D3a to pentode? nt - Salectric 15:17:17 04/25/07 (1)
- Re: What is the gain when you switched the D3a to pentode? nt - Stephen R 01:45:01 04/26/07 (0)
- Re: DIY phone stage recommendation for.. - danlaudionut 18:24:59 04/24/07 (0)
- Re: DIY phone stage recommendation for.. - Vinnie 15:30:24 04/24/07 (0)