Pin config on various balanced(XLR) components....

Pro Audio Asylum

Pro studio recording equipment and music production/industry.

209.17.181.33

I have a situation where I am trying to integrate a sub into my audio set up. Currently I am running a EMM Switchman 111 and a Linar Audio 250i power amp. I am trying to add a Genelec 7070A sub and am running into a problem. It almost seems as if I have an incompatibility with the XLR connectors on the equipment. The line up is as follows;
EMM 1 gnd Linar 1 gnd 7070A 1 gnd
2 + 2 - 2+
3 - 3+ 3-
I have had no problem running the Linar and Emm units together even though they seem to be out of sync as far as pins config go. I added in the 7070A by going from the Emm preamp to the sub and out of the sub to the power amps. No signal is present. I went direct to the sub from a dvd player LFE out and was able to generate output. Any ideas as to why the balanced through connection isn't working? Do I need to get XLR's wired specifically to mate with the the pin differences? Any help would be appreciated. Thanks,

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

Topic - Pin config on various balanced(XLR) components.... - not me 09:52:03 03/29/05 (0)

You can not post to an archived thread.