In Reply to: Thanks, Joe, but the 3800 set-up is pretty limited... posted by TL-CHI on March 12, 2004 at 09:05:06:
>>>For the LPCM set-up, selecting the 'on' position does enable the digital output, but only after downmixing from 96Khz to 48Khz (the 3800 has no setting for 96 vs. 48, per se).<<<Page 18 of the manual says to set this to "off" in order to get 24/96 on the digital outputs. So the setup should be "normal" and "off" for a 24/96 signal to be sent to a receiver/processor.
You might want to do a search on AVS Forum in the "Receivers and Processors" section to find out if the AVR2803 has analog pass-thru on any of the stereo inputs.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- not quite right - Joe Murphy Jr 16:27:38 03/12/04 (0)