Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: I don't know anyone vertical biamping but posted by John Elison on May 27, 2017 at 22:47:14:
You sure? Not buffered in any way? (opamp is what I'm thinking)
Any circuit diagrams available? I would also like to know the value of the attenuator for possible replacement by a couple resistors OR a single gang stepped attenuator.
Even IF impedance is 'cut in half', just like using a 'Y' adaptor, the Parasound solution is easier. I needed only to use a short single ended jumper. Maybe 18" or so, and could have used less.
It also couples to the Balanced out, but I'm not sure how that is worked.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I don't know anyone vertical biamping but - pictureguy 00:24:02 05/28/17 (13)
- RE: I don't know anyone vertical biamping but - John Elison 05:46:54 05/28/17 (1)
- RE: I don't know anyone vertical biamping but - pictureguy 09:36:21 05/28/17 (0)
- RE: I don't know anyone vertical biamping but - Kingshead 04:02:13 05/28/17 (10)
- RE: I don't know anyone vertical biamping but - pictureguy 09:30:00 05/28/17 (9)
- RE: I don't know anyone vertical biamping but - Kingshead 10:52:49 05/28/17 (8)
- RE: I don't know anyone vertical biamping but - pictureguy 12:05:47 05/28/17 (7)
- RE: I don't know anyone vertical biamping but - Kingshead 13:17:59 05/28/17 (6)
- RE: I don't know anyone vertical biamping but - pictureguy 17:03:56 05/28/17 (2)
- RE: I don't know anyone vertical biamping but - Kingshead 20:11:38 05/28/17 (1)
- RE: I don't know anyone vertical biamping but - pictureguy 21:22:31 05/28/17 (0)
- RE: I don't know anyone vertical biamping but - pictureguy 14:38:43 05/28/17 (2)
- RE: I don't know anyone vertical biamping but - Kingshead 16:13:46 05/28/17 (1)
- RE: I don't know anyone vertical biamping but - pictureguy 17:21:58 05/28/17 (0)