In Reply to: RE: Need light weight amps to drive Mg 1.7 after loss of Emotiva's posted by Utley1 on October 13, 2021 at 18:42:59:
'High Current', is IMO a red herring 'spec'.
Measured for a VERY short time and at a very low output voltage........Not really something your speakers can make use of.
EMO had the PA-1, a 'd' amp based on the B&O ASC module. It was a HIT and now commands over-list used prices!
IMO? If you are DIY inclined? Check ou the HYPEX webside. A Pair of the NC400 modules and a power supply? Depending on case, the weight should be EASY on your back / legs. One per speaker IF they'll biamp, would be perfecto.....
EMO dodged the XPA-1 bullet by going to a SMPS for the new generation AND thereby cutting a lot of weight. No telling how much the Toroid of maybe 1.6KvA or whatver actually weighed.
Shipping damage was KILLING them. I'd ship a pair on a pallet, but nobody went to that trouble IF they had to send 'em back fo repair. An Insurance Nightmare, to be sure.......
I don't know if EMO will part with the Schematic or NOT?
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Need light weight amps to drive Mg 1.7 after loss of Emotiva's - pictureguy 18:50:52 10/13/21 (2)
- RE: Need light weight amps to drive Mg 1.7 after loss of Emotiva's - Utley1 19:48:53 10/13/21 (1)
- RE: Need light weight amps to drive Mg 1.7 after loss of Emotiva's - pictureguy 21:48:52 10/13/21 (0)