|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Key... Active measurement Assistance... posted by BigguyinATL on October 13, 2016 at 09:26:32:
If you read again, I said "requires no acoustic testing."
Electrical-only testing (at each transducers terminals) may be required, and it has the distinct advantage of not containing any of the pitfalls acoustic testing (or listening) might. It also incorporates all parasitic characteristics of the crossover components.However, computer simulation will achieve nearly the same level of accuracy electrical testing will......assuming the components in the simulation are fairly good. Simulation of Magnepan transducer and crossovers are more straightforward in this aspect since the driver impedance's are essentially resistive. Neo's spreadsheet contains electrical transfer functions of Magnepan speakers he's never measured (either electrically or acoustically), yet I believe them to be very accurate depictions.
Cheers,
Dave.
Edits: 10/13/16 10/13/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Key... Active measurement Assistance... - Davey 09:38:18 10/13/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
