RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's

Considering the XOs he has the relative output and absolute voltage available should allow for compensation for a low gain tweeter amp.

That is unless he bought the mono horn amp which has deliberately reduced gain by 18 db. But that one does not spec a 2ohm tap

Mini Specifications
Power Output 25 watts into 2, 4 or 8 ohms
Power Bandwidth 13 Hz to 50 KHz
Peak Power 50 watts
Input Sensitivity 1 volt
Input Impedance 100 Kohms

88 mono Specifications
Power Output 80 watts into 4 or 8 ohms from 20Hz to 20 KHz
Power Bandwidth 13 Hz to 80 KHz
Input Sensitivity 1 volt
Input impedance 100 K ohms
Damping Factor 15
IM Distortion 1% or less at 80 watts

Mono Horn amp Specifications
Power Output 25 watts into 4 or 8 ohms
Power Bandwidth 15 Hz to 100 KHz
Peak Power 50 watts
Damping Factor 20
Input Sensitivity 6 volts
Input Impedance 100 Kohms

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - ejhoove 08:46:14 04/25/15 (16)

Did it work? - Satie 16:09:24 04/30/15 (5)

RE: Did it work? - ejhoove 02:26:39 05/01/15 (3)

RE: Did it work? - ejhoove 03:43:18 05/02/15 (2)

RE: Did it work? - Satie 15:13:38 05/02/15 (1)

RE: Did it work? - ejhoove 19:38:13 05/02/15 (0)

RE: Did it work? - ejhoove 16:45:14 04/30/15 (0)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Satie 09:57:42 04/26/15 (9)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - ejhoove 10:14:23 04/26/15 (8)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Davey 09:12:40 04/27/15 (5)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Satie 10:33:30 04/27/15 (0)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - ejhoove 10:29:40 04/27/15 (3)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Davey 10:54:50 04/27/15 (2)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - ejhoove 14:00:26 04/27/15 (1)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Davey 18:21:34 04/27/15 (0)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Satie 08:34:15 04/27/15 (0)

RE: "I have not been able to get the amount of volume out of the riboons with the Mini monos (30w each)" ... - andyr 16:05:21 04/26/15 (0)

Follow Ups

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's - Satie 10:33:30 04/27/15 (0)

RE: Quicksilver tubes on the midrange panels/ribbons - MGIIIa's

Post a Message!