|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Setup posted by Dawnrazor on August 2, 2010 at 07:51:07:
What does swapping +- speaker leads do that my amp's phase switch doesn't? I'm maybe a little confused!
Now, with an additional variable there is an additional set of tests.
Here's the breakdown. In absolute fairness to the 'scientific method' all must be listened to. If I wanted to be REAL fair, I'd drag the wife into it and ask for her opinion.
Tests:
Mylar front/back: Tweeter in/out: Tweeter spacing wide/narrow Phase +/-
Internal wiring? STD/ swap tweeter phase? :: The number of tests skyrockets as a function of the number of variables.
The phase wiring of drivers is usually because the crossover introduces phase shifts. So, if you are using a first order hi pass you have what....an automatic 90` shift and 2nd order at 180`.
Doesn't the 1.6 have one of each? Isn't the tweeter wired out of phase? Is a rule of thumb of 90` per order OK to use?
Lot's of testing ahead should I get that motivated. I always dread moving stuff around.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Setup - pictureguy 10:55:15 08/02/10 (1)
- RE: Setup - Dawnrazor 08:01:00 08/03/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
