|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
172.11.32.65
In Reply to: RE: How to devise a single-ended output from a balanced preamplfier posted by Lew on July 12, 2024 at 12:42:34
If it is 100K, then you just need to take the signal off the positive and put a 100K resistor from the negative leg to ground. One resistor
Follow Ups:
I haven't purchased the subwoofs yet, but I can certainly find out the input impedance of the built-in amplifiers. I hate to reveal my ignorance or at least my insecurity, but I assume you mean the negative phase of the balanced output, when you refer to the "negative leg". Then connect the ground lug on the RCA SE output jack to ground per usual.
That couldn't be simpler.
Not all balanced outputs are referenced to ground. This should be confirmed by reviewing the specs or the schematic for the preamp before proceeding.
Exactly.
In a pure balanced line, there is no ground. There is only a shield, which is NOT the signal ground of components at either end. This is best implemented with a transformer. In that case, you can ground one end of the secondary to get a single-ended connection.
Many (most?) modern balanced components are more like differential lines, where there are two signal paths in opposite phase, which share a common signal ground. This is a decent approximation as long as the impedance to the source's common signal ground is much, much smaller than the receiver's impedance to ground. That means you can't just connect one side to ground.
Many problems are caused by the confusion between signal and shield grounds ... :^)
Yes. Ground is floated at the balanced outputs. Which is why I originally thought I needed to use a transformer, in the way that you mention which is to ground one side of the secondary while taking the SE signal off the other side of the secondary.
Edits: 07/13/24 07/13/24
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: