Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Do your voltages somewhat match the schematic? (nt)

Posted by vinnie2 on June 21, 2017 at 13:42:38:
Check the voltages and did not see any that were way off from what is on the schem, but they were bouncing around a bit instead of holding steady. I think I will have to assume I have something hooked up wrong and strip it down and redo the wiring unless someone has some other idea to check out. At least with the breadboard it will take less than an hour to redo the wiring. Love those breadboards!