Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: What about the push-pull magnets in the 20 series Maggies? NT

Posted by pictureguy on November 13, 2021 at 15:24:09:
I suggested stronger magnets YEARS ago and was met with crickets.

You could, with such magnets increase the pole piece / driver spacing a little......still gain some sensitivity while lower chances of bottoming out.....

You MUST replace those refrigerator magnets with something of greater flux density.
But ALSO must be careful. VERY strong magnets can be dangerous. Everthing from a pinch event to stuff 'sticking'. Neo matnets are also brittle so you have THAT to look forward to...

between parts, fabrication and training, costs would go up...