Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Typical solid state amps have highest distortion at lowest levels

Posted by Feanor on September 29, 2013 at 05:24:13:
So, if my understanding is right, operating in class A mode is a way to mitigate distortion at low levels of power.

According to Emotiva, the XPA-1L can set to operate class AB from a low lever OR to operate class A up to 35 at the expense of greater heat and power consumption.