RE: AR Turntable tonearm question

Posted by hahax@verizon.net (A) on August 2, 2022 at 21:37:40

In Reply to: RE: AR Turntable tonearm question posted by George S. Roland on August 2, 2022 at 14:57:37:

I used a Decca 4RC in an AR arm with good results. As above remove the clutch pin on the inside of the arm pivot. It dampens the arm descent if you drop the arm accidentally. But it can also be activated by record warp(find me a totally flat record) in which case the pickup loses full contact with the record, probably a source for many of the complaints against the arm.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - AR Turntable tonearm question - George S. Roland 20:29:23 08/01/22 (15)

RE: AR Turntable tonearm question - John Elison 16:42:45 08/05/22 (2)

"piece of junk . . ". Pretty strong words John. The AR-XA tonearm is - alaskahiatt 23:05:29 08/07/22 (1)

notable hallmark of progress - Story 03:34:12 08/08/22 (0)

RE: AR Turntable tonearm question - 6bq5 10:23:47 08/05/22 (0)

that design goes way back... - Story 13:24:01 08/04/22 (0)

Edgar Villchur's advice on anti-skating - Lew 09:09:27 08/04/22 (1)

RE: Edgar Villchur's advice on anti-skating - JonM 09:18:14 08/05/22 (0)

always strive for the best possible arm - beach cruiser 23:09:42 08/02/22 (0)

RE: AR Turntable tonearm question - Bill Way 15:40:52 08/02/22 (1)

RE: AR Turntable tonearm question - Tre' 16:25:05 08/02/22 (0)

RE: AR Turntable tonearm question - Basher52 09:04:10 08/02/22 (4)

RE: AR Turntable tonearm question - George S. Roland 14:57:37 08/02/22 (3)

AR Turntable tonearm question (cont.) - Basher52 08:00:17 08/03/22 (1)

addendum to the addendum - beach cruiser 15:27:31 08/03/22 (0)

RE: AR Turntable tonearm question - hahax@verizon.net 21:37:40 08/02/22 (0)

Follow Ups

RE: AR Turntable tonearm question - hahax@verizon.net 21:37:40 08/02/22 (0)

RE: AR Turntable tonearm question

Post a Message!