|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: How do I test DC leakage from my SS integrated amp? posted by FCS on March 14, 2003 at 15:21:45:
and the cheapests are digital...
You are looking for voltages in the range 10-500 mV (a thousand of a volt).
Switch on the amp. Disconnect speakers. Switch on amp. Set meter on DCV range. Connect meter in speaker output (polarity don't matter).
Read results (wait for amp to warm-up before final reading).
A few hundreds millivolts is tolerable, more is not. If you can adjust, target should be less then 50mV.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- You will need an electronc multimeter - Benoit 01:28:35 03/17/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
