|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Calling all roller bearing users posted by Brad V on December 7, 2002 at 20:11:30:
I did experience the bearings digging into the finish. To solve the problem I purchased some 2"x2"x1/4" 6061-T6 hard aluminum plate from ONLINE MEATALS at the link below. (scroll to bottom of page for custom sizes) I had to sand the extrusion marks with crocus cloth and a finishing(vibrating) sander. Then I polished them to a mirrored finish(w/sander and cotton rag)using MAAS Metal Polish, available at your local Wal-Mart. There was an overall improvement from top to bottom, much like I precieved when I first put the bearings in my system, although not quite as signifigant. The improvement was well worth the time effort and small cash outlay in my system. As usual YMMV.
Good Luck
Julien Therrien
jntherrien@msn.com
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Calling all roller bearing users - Julien43 23:08:30 12/07/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
