|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: flexiholes posted by Ortem on October 26, 2001 at 02:49:10:
With a spade bit, first make a small mark with a bradle or even just a large nail. That way you can "feel" the point of the bit into the right position. Are you using a bench mounted drill? Its much more accurate especially for getting it vertical.
Drill in a little and come out. Do this a few times as you go through, it allows the bit to clear better.
If you put a scrap piece of wood or something similar under the MDF, you won't get tear out from the underside.
Use a high speed for the drill and don't force the bit into the MDf, let the blades do the work.
It only takes a few seconds to do so its better to do it right!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- the whole story - dave c 13:31:28 10/26/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
