|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: DIY Constrained layer platforms posted by DSK on September 24, 2001 at 19:21:05:
I made mine by vacuum bagging carbon fibre fabric in epoxy into 2mm thick plates and bonding it with NCMS Soft Glue to 30mm thick 2 pound blue closed cell foam.The carbon gives an extremely stiff, hard and non-resonant surface layer and the blue foam is very lossy. I assembled three of these into a Flexy rack per TNT with Sorbathane above and below the carbon/foam shelves, it works very well.
I think for the Audio Industry to offer something like this would be frighteningly expensive but I build mine for cheap and some elbow grease.
DIY Rules.
Tony D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: DIY Constrained layer platforms - Tony D. 09:50:25 09/25/01 (3)
- Re: DIY Constrained layer platforms - Msquared 19:25:02 09/25/01 (0)
- Re: DIY Constrained layer platforms - DSK 16:59:12 09/25/01 (1)
- Re: DIY Constrained layer platforms - Tony D. 19:00:12 09/25/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
