|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Thanks... posted by Nate on November 20, 2000 at 09:52:36:
The op-amps make a HUGE impact, as do the signal path resistors. The input 1kohm resistors,the output 100-220ohm resistors, and the 20kohm feedback resistors should all be upgraded to Caddock or Vishay's of the same value, with the exception of the 100-220ohm (depending on which model of Link DAC) should be replaced with 75ohm resistors. I would also recommend replacing the digital input resistor (100ohm) with a Caddock/Vishay 75ohm. You can also snip out the resistors at the analog outs and the two 1000pf caps beside the white switching relay...I found it sounded better with those out of the circuit.Good luck and take it slow, the board is fragile.
Dan W.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Thanks... - Dan W 11:18:40 11/20/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
