|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Soldering job advice needed posted by ArdRi on October 3, 2008 at 17:08:52:
If it is possible to remove the board and motor, and then get a pair of cutting pliers between the motor and board such that you can cut each off, you will have a MUCH easier time desoldering the remnant, independent pieces. There may not be enough clearance for the pliers though.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Soldering job advice needed - RioTubes 12:47:03 10/04/08 (4)
- Thanks for the tip but its not possible - ArdRi 12:59:24 10/04/08 (3)
- RE: Thanks for the tip but its not possible - rick_m 14:39:38 10/04/08 (2)
- its all moot now. I reassembled the piece and.... - ArdRi 15:06:19 10/04/08 (1)
- RE: its all moot now. I reassembled the piece and.... - rick_m 07:21:44 10/05/08 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
