|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: calling EE's posted by Mart on May 17, 1999 at 23:32:14:
Will you please stop calling tube amps current sources? A lot of SET's only have about 1.2 ohms output impedance and most push-pull designs are only about 0.5 ohms.That does not meet any EE's definition of a current source.The 1000 ohm resistor used by most people in T/S parameter measurments can cause a 20% error in Qes when checking series vs parallel on DVC drivers if they don't re-adjust the voltage of the generator to keep the current constant.Get off it,please.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: calling EE's - abc 03:34:20 05/18/99 (2)
- O.K. ... fine ... - Mart 06:21:21 05/18/99 (1)
- Re: O.K. ... fine ... - Victor Khomenko 06:58:29 05/18/99 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
