|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
This 2 position rotary switch is a DPDT (see link). Would be interested in using as an On/Off switch. How do I wire it? My experience is limited to SPST toggles.I want to take the the hot pin of IEC inlet to a fuseholder, and from fuseholder to this Switch, and then from switch to positive lead of transformer. I want to take the neutral on IEC inlet direct to neutral lead of transformer, and IEC earth to chassis ground. Can I wire this DPDT in this arrangement and, if so, how? It has 6 pins. It's rated 5amps.
This post is made possible by the generous support of people like you and our sponsors:
Topic - How do I wire this switch? - RioTubes 10:01:53 10/22/06 (11)
- Re: How do I wire this switch? - Kunzwerks 11:31:59 10/22/06 (10)
- Check with a test meter (ohms) - clifff 11:45:35 10/22/06 (9)
- like this? - RioTubes 12:41:15 10/22/06 (8)
- "but does it matter which outer pin...lower or upper (of each grouping of 3s) I jump from? " - clifff 13:27:27 10/22/06 (7)
- Re: "but does it matter which outer pin...lower or upper (of each grouping of 3s) I jump from? " - Kunzwerks 13:40:10 10/22/06 (6)
- I think I got it - RioTubes 14:26:44 10/22/06 (5)
- That depends - clifff 14:39:11 10/22/06 (4)
- OK Cliff. Like This? - RioTubes 15:41:04 10/22/06 (3)
- PS: The picture you drew is accurate ..ie; it will work. nt - Kunzwerks 17:45:05 10/22/06 (0)
- Lets keep it simple - Kunzwerks 17:40:20 10/22/06 (1)
- Thanks very much Kunzwerks and Cliff! - RioTubes 17:47:24 10/22/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
