|
Speaker Asylum General speaker questions for audio and home theater. |
|
|
|
Speaker Asylum General speaker questions for audio and home theater. |
|
In Reply to: Re: How does bi-wiring work? posted by Jon Risch on December 23, 2000 at 15:54:55:
Stereophile did some tests a few years ago and burried in the article
was the fact that they didn't see the benifit of biwire. It would be too difficult for me to look this up. I wrote to the John Mruphy who wrote the Winspeak simulation program. He wrote back that he saw no benifit in bi-wiring.I have measured speakers with and without using the LMS and Clio systems. These systems can detect any variation in the signal (I know that audiophiles think that the ear is more sensitive that insturments). If there is a difference, it should be measurable.
By the nature of the single connection point, the woofer and tweeter are certainly part of the same circuit. The only way to seperate the signals is to have seperate source and destination.
As I said earlier, most crossovers have more cicuitry than and high pass and low pass filter.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: How does bi-wiring work? - mbarnes 21:51:29 12/26/00 (3)
- Re: How does bi-wiring work? - Jon Risch 13:02:21 12/27/00 (2)
- Re: How does bi-wiring work? - JROY 09:43:14 12/28/00 (1)
- Re: How does bi-wiring work? - Franco 08:52:27 12/30/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
