Linn Ninka question.

Speaker Asylum

General speaker questions for audio and home theater.

I can ask to the following to Linn or my dealer on Monday, but have today(Sunday) to tinker and want to set it up for passive bi-wiring.

I removed the back collars and removed the link board ---there was only the one as opposed to the two mentioned in the manual, and they are marked slightly differently than the manual. On the reverse of the one removed was 'Active Bi-Amp' and the one showing on the speaker which can't be removed says 'Active Tri-Amp'--(same for both speakers, so this is intentional). It occurred to me that the link board perhaps does nothing but tell you which inputs to use for the configuration--is that true? If so all I need to do is remove the righmost upper two plastic plugs and use that as the second input on the speaker for bi-wire--is this correct? (This would match the inputs in the manual for bi-wiring and bi-amping,(non-active). Also, this bring up the question, on a typical speaker, you must use jumpers when not bi-wiring, so how does the Ninka compensate for this?

Anyway, thanks for your help!

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

Topic - Linn Ninka question. - silence 23:48:50 03/31/07 (2)

Re: Linn Ninka question. - b-flat 22:38:13 04/01/07 (1)

Yes, I did both. - silence 01:11:18 04/02/07 (0)

You can not post to an archived thread.