Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Newbie bias voltmeter readings question posted by hartwerger on November 30, 2006 at 17:30:45:
To do so you'll have to break the loop and get in series. So unless you were given a parallel tap to measure on, you would have to measure Mv. To do so usually you would measure voltage drop(Mv) across both sides of a resistor. A simple formula (Ohm's law, I=E/R) will give the current reading.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- How did you measure Ma? - bluelobster 18:22:25 11/30/06 (0)