|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Where would i put the ferrite beads? posted by Tre' on January 16, 2017 at 19:14:58:
The amp was stable for about 10 minutes then slowly the cathode current of the 6550 started to tick up, and then it picked up speed and i shut it down. I also put in a grid stopper on the input/driver tube. I put the ferrite bead on the wire lead to the grid stopper. it is short not even 2". Maybe i should go with a shielded input wire? The run is short as i said.
Edits: 01/16/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- It helped a little. - DAK 20:47:41 01/16/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
