|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
|
|
Bottlehead Forum Welcome! Need support, you got it. Or share you ideas and experiences. |
|
In Reply to: Re: I seriously liked those Fostex FR's... posted by pboser@yahoo.com on September 17, 2003 at 20:04:56:
Sure. The internal dimensions were 11.5"(w) x 18.5"(h) x 8"(d). Material was plain old 3/4" MDF. The port is on the rear panel and measures 2" diameter x 2.75" long. I mounted the driver 6" down from the top inside edge. Stuffing was about 0.25lb of Holofil or equivalent. At this point there are no internal braces. Internal wiring was simple 20awg single strand copper magnet wire.I mounted the speaker on the wide side of the enclosure in an attempt to push the baffle step effect down a little lower in frequency, and I liked the way they look. There's no reason the driver couldn't be mounted on the narrow side. The port was to the rear in the hope of getting a little extra bass gain from the rear wall.
Hope this helps. This turned out to be a very nice sounding speaker at a budget price.
DaveJ
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: I seriously liked those Fostex FR's... - DaveJ 04:19:48 09/18/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
