In Reply to: Re: Fplay MKII posted by GLF on September 13, 2003 at 18:09:23:
Ok, sorry for the unclear post, I will try and be more clear.I am building a dual mono power supply. I am using Hammond 187B120 power transformers that are 115v primary and 120v secondary. From there I have the RRSF then a diode bridge using 1UF4007s. Then 3 220uf caps with 2.2kohm resistors in between.
That is for each channel.
The voltage after the diodes is 204 volts and after the caps it is 202 volts. This is just the power supply being tested, with no load. How do I figure out what resistor values to use to get the voltage to 157 or somewhere around there? Thanks
Andrew
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Clarification - GLF 10:54:21 09/14/03 (2)
- Don't worry about the voltage... - Paul Joppa 11:10:03 09/14/03 (1)
- Re: Don't worry about the voltage... - GLF 11:15:40 09/14/03 (0)